Dell Embedded Box PC 5000 - Replacing the Solid-State Drive in to Bracket; Prerequisites; Procedure

Replacing the solid-state drive
in to bracket
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
Before working inside your Embedded Box PC.
After working inside your Embedded Box PC, follow the steps in After
working inside your Embedded Box PC. For more safety best practices,
see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling
the solid-state drive.
Prerequisites
1 Follow step 1 to step 6 in “Removing the back cover”.
2 Remove the drives from the hard-drive cage.
Procedure
NOTE: Embedded Box PC is shipped with hard drive, solid-state drive, or
both, depending on the configuration ordered.
1 Remove the screw that secures the solid-state drive to the solid-state
drive bracket.
29