Dell Embedded Box PC 5000 - Removing the Interposer Board; Prerequisites; Procedure

Removing the interposer
board
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
Before working inside your Embedded Box PC.
After working inside your Embedded Box PC, follow the steps in After
working inside your Embedded Box PC. For more safety best practices,
see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1 Follow step 1 to step 6 in “Removing the back cover”.
2 Remove the drives from the hard-drive cage.
3 Remove the solid-state drive from bracket.
Procedure
1 Remove the screws that secure the interposer board to the solid-state
drive card bracket.
32