Dell Embedded Box PC 5000 - Removing the Top Cover; Prerequisites; Procedure

Removing the top cover
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
Before working inside your Embedded Box PC.
After working inside your Embedded Box PC, follow the steps in After
working inside your Embedded Box PC. For more safety best practices,
see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Follow step 1 to step 6 in “Removing the back cover”.
2 Remove the PCI/PCIe card (if installed).
3 Remove the riser card.
Procedure
1 Disconnect the power-switch cable and remove it from the routing
guides on the chassis.
2 Disconnect the power-connector cable and intrusion-switch cable from
the system board.
3 Remove the screw that secures the grounding cable to the system board.
95