Dell Embedded Box PC 5000 - Removing the Heat Sink; Prerequisites; Procedure

Removing the heat sink
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
Before working inside your Embedded Box PC.
After working inside your Embedded Box PC, follow the steps in After
working inside your Embedded Box PC. For more safety best practices,
see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Follow step 1 to step 6 in removing the “back cover”.
2 Remove the PCI/PCIe card (if installed).
3 Remove the memory module.
Procedure
1 Remove the screws that secure the chassis heat-sinks to the sides of the
chassis.
2 In sequential order (as indicated on the heat sink), remove the screws that
secure the heatsink to the CPU board.
99