Replacing the WLAN-antenna
connectors
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
Before working inside your Embedded Box PC.
After working inside your Embedded Box PC, follow the steps in After
working inside your Embedded Box PC. For more safety best practices,
see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 Insert the WLAN-antenna connectors into the WLAN-antenna connector
slots on the bottom cover.
NOTE: Insert the WLAN-antenna connectors based on the color
indicated behind the bottom cover.
2 Replace the nuts and washers that secure the WLAN-antenna connectors
to the bottom cover.
3 Route the WLAN cables through the routing guides on the chassis.
4 Connect the WLAN-antenna cables to the WLAN card.
The following table provides the antenna-cable color scheme for the
WLAN card supported by the Embedded Box PC.
Connectors on the WLAN card Antenna-cable color
Main (white triangle) White
Auxiliary (black triangle) Black
Post-requisites
1 Replace the PCI/PCIe card (if necessary).
2 Follow step 2 to step 9 in “Replacing the back cover”.
55
To Next Page
Loading...
