Dell Embedded Box PC 5000 - Removing the WLAN Card; Prerequisites; Procedure

Removing the WLAN card
WARNING: Before working inside your Embedded Box PC, read the
safety information that shipped with your Embedded Box PC and
follow the steps in
Before working inside your Embedded Box PC.
After working inside your Embedded Box PC, follow the steps in After
working inside your Embedded Box PC. For more safety best practices,
see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Follow step 1 to step 6 in “Removing the back cover”.
2 Remove the PCI/PCIe card (if installed).
Procedure
1 Disconnect the antenna cables connected to the WLAN card.
2 Remove the screws that secure the WLAN-card bracket to the system
board.
3 Remove the WLAN-card bracket from the WLAN card.
56