199
NOTICE: You must position the processor correctly in the socket to avoid permanent damage to the
processor and the computer when you turn on the computer.
3
If the release lever on the socket is not fully extended, move it to that position.
4
Orient the front and rear alignment-notches on the processor with the front and rear alignment-
notches on the socket.
5
Align the pin-1 corners of the processor and socket.
NOTICE: To avoid damage, ensure that the processor aligns properly with the socket, and do not use
excessive force when you install the processor.
6
Set the processor lightly in the socket and ensure that the processor is positioned correctly.
7 When the processor is fully seated in the socket, close the processor cover.
1 processor cover 6 release lever
2 tab 7 front alignment-notch
3 processor 8 socket and processor pin-1 indicator
4 processor socket 9 rear alignment-notch
5 center cover latch
1
3
4
6
8
7
9
2
5
To Next Page
Loading...
