93
NOTICE: When replacing the processor, do not touch any of the pins inside the socket or allow any
objects to fall on the pins in the socket.
1
Follow the procedures in "Before You Begin."
2
Unpack the new processor, being careful not to touch the underside of the processor.
NOTE: You must position the processor correctly in the socket to avoid permanent damage to the
processor and the computer when you turn on the computer.
3
If the release lever on the socket is not fully extended, move it to that position.
4
Orient the front and rear alignment-notches on the processor with the front and rear alignment-
notches on the socket.
5
Align the pin-1 corners of the processor and socket.
1 processor cover 6 release lever
2 tab 7 front alignment-notch
3 processor 8 socket and processor pin-1 indicator
4 processor socket 9 rear alignment-notch
5 center cover latch
1
3
4
6
8
7
9
2
5
To Next Page
Loading...
