94
www.dell.com | support.dell.com
NOTICE: To avoid damage, ensure that the processor aligns properly with the socket, and do not use
excessive force when you install the processor.
6
Set the processor lightly in the socket and ensure that the processor is positioned correctly.
7 When the processor is fully seated in the socket, close the processor cover.
Ensure that the tab on the processor cover is positioned underneath the center cover latch on the
socket.
8 Pivot the socket release lever back toward the socket, and snap it into place to secure the
processor.
NOTICE: If you are not installing a processor upgrade kit from Dell, reuse the original heat sink
assembly when you replace the processor.
If you installed a processor replacement kit from Dell, remove the original heat sink assembly
from the shroud and return it with the processor to Dell in the same package in which your
replacement kit was sent.
9 Install the heat sink assembly:
a Place the heat sink assembly back onto the heat-sink assembly bracket.
b Rotate the heat sink assembly down towards the computer base and tighten the two
captive screws.
NOTICE: Ensure that the heat sink assembly is correctly seated and secure.
To Next Page
Loading...
