Figure 123. Removing the status LED control panel for Front Accessed configuration
Next steps
Replace the status LED control panel.
Installing the status LED control panel
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the expansion card riser 2
4. Remove the air shroud
5. Remove the expansion card riser 1
Steps
1. Route the control panel cable through the guide slots in the system and connector on system board.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the status LED control panel assembly in the slot on the system.
3. Using the Torx #8, tighten screws from status LED control panel assembly.
4. Using the Phillips #2, tighten screws from rack ear assembly.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
112 Installing and removing system components
To Next Page
Loading...
