Dell PowerEdge XR12

Figure 24. Removing the bezel filter for Front Accessed configuration
Next steps
1. Replace the bezel filter.
2. Install the bezel.
Installing the bezel filter
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the bezel.
Steps
1. Place the new filter in the bezel cavity under the filter bracket. Ensure that the filter is smooth and flush in the allowed
cavity.
2. Slide the side latches open to allow the filter to be placed into the bezel. Ensure the filter is square in the allowed cavity and
that the two side latches have closed.
30
Installing and removing system components