CAUTION:
Before you begin any of the procedures
in
this section,
follow
the safety instructions
in
the
Product
Information
Guide
.
PC
Card
1
Hold the
card
with its
orientation symbol pointing
into the
slot and
the top
side
of the
card facing
up.
The latch may need
to
be
in the "in"
position before you insert
the card.
2 Slide
the
card
into the
slot
until the
card is completely seated
in its connector.
If
you encounter
too
much resistance, do
not
force
the
card. Check
the
card orientation and
try again.
The
computer recognizes most
cards
and automatically loads
the
appropriate device driver.
If the
configuration program tells you
to
load
the
manufacturer's drivers, use
the floppy
disk
or CD that came
with the
PC
Card.
ExpressCard
1
Hold the
card
with its
orientation symbol pointing
into the
slot and
the top
side
of the
card facing
up.
The latch may need
to
be
in the "in"
position before you insert
the card.
2 Slide
the
card
into the
slot
until the
card is completely seated
in its connector.
If
you encounter
too
much resistance, do
not
force
the
card. Check
the
card orientation and
try again.
60
Using
Cards
To Next Page
Loading...
