Dell PP04X - Changing COM Ports

Performing a One-T i me Boot
You can set a one-time-only boot sequence without entering the system setup program. (You can also use
this procedure to boot the Dell Diagnostics on the diagnostics utility partition on your hard drive.)
1 Shut down the computer through the Start menu.
2 If the computer is connected to a docking device (docked), undock it. See the documentation that
came with your docking device for instructions.
3 Connect the computer to an electrical outlet.
4 Turn on the computer. When the DELL logo appears, press <F12> immediately. If you wait too long
and the W i ndows logo appears, continue to wait until you see the Windows desktop. Then shut down
your computer and try again.
5 When the boot device list appears, highlight the device from which you want to boot and pr ess
<Enter>.
The computer boots to the selected device.
The next time you reboot the computer, the previous boot order is r e stor e d.
Changing COM Ports
Serial Port, which is located in the Onboard Devices category, allows you to map the serial port COM
address or disable the serial port and its address, which frees computer resources for another device to
use.
System Setup Program 95