b eDP
4 Place the metal bracket and tighten the M2.5x5.0 screw to secure the eDP cable to the computer.
5 Install the:
a heat sink
b I/O board (right)
c I/O board (left)
d palmrest
e power connector port
f graphic card
g M.2 SSD card
h WWAN card
i WLAN card
j primary memory
k secondary memory
l HDD cable
m keyboard
n hard drive
o base cover
p battery
q battery cover
r SD card
6 Follow the procedure in After working inside your computer.
Fingerprint reader
Removing the ngerprint reader
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a SD card
b battery cover
c battery
d base cover
e hard drive
f keyboard
g hard drive cable
h secondary memory
i primary memory
j WLAN card
k WWAN card
l M.2 SSD card
m graphic card
n power connector port
o palmrest
3 To remove ngerprint reader:
a Peel the adhesive tape that secures ngerprint reader [1].
b Remove and lift the M2.0X3 screws that secure metal bracket on the chassis [2].
c Disconnect the cable and lift the ngerprint reader from the chassis [3].
34
Disassembly and reassembly
To Next Page
Loading...
