4 To remove display panel:
a Peel the adhesive tape to access the eDP cable [1].
b Remove the blue adhesive tape [2].
c Lift the metal tab display panel [3].
d Disconnect the cable and lift the display panel.
Installing the display panel
NOTE
: For non touch systems perform following steps.
1 To install the display panel:
a Connect the eDP cable to the connector on the back of the display panel and ax the adhesive tape.
b Align the display panel with the tabs on the display assembly.
c Replace the M2.0X3 screws to secure the display panel to the display assembly.
2 Install the:
a display bezel
b display assembly
c palmrest
d keyboard
e hard drive
f base cover
g battery
h battery cover
3 Follow the procedure in After working inside your computer.
Disassembly and reassembly
45
To Next Page
Loading...
