119
See the documentation that came with the card for information on configuring the
card, making internal connections, or otherwise customizing it for your computer.
CAUTION: Some network connectors automatically start the computer when they
are connected to a network. To guard against electrical shock, be sure to unplug
your computer from its electrical outlet before installing any cards. Verify that
the standby power light on the system board is off. To locate this light, see the
system board illustration
(for the Dell Precision 450 computer, see"System Board
Components" or for the Dell Precision 650 computer, see "System Board
Components" ).
5
Place the card in the connector and press down firmly. Ensure that the card is fully
seated in the slot.
If the card is full-length, insert the end of the card into the card guide bracket as you
lower the card toward its connector on the system board. Insert the card firmly into the
card connector on the system board.
6 Before you lower the retention arm, ensure that:
1 fully seated card
2 not fully seated card
3 bracket within slot
4 bracket caught outside of slot
To Next Page
Loading...
