190 Solving Problems
www.dell.com | support.dell.com
A REQUIRED .DLL FILE WAS NOT FOUND — The program that you are
trying to open is missing an essential file. To remove and then reinstall the
program:
1 Click the Start button.
2 Click Control Panel.
3 Click Add or Remove Programs.
4 Select the program you want to remove.
5 Click the Change or Remove Program icon.
6 See the program documentation for installation instructions.
ALERT! CARD CAGE FAN FAILURE — The PCI card cooling fan is not
installed, has failed, or is not properly connected to the system board. Ensure that
an operational fan is properly installed and connected to the system board. For
more information, see the Service Manual at support.dell.com.
NOTE: This error message applies only to Dell Precision™ 650 computers.
ALERT! CHIPSET HEATSINK NOT DETECTED — The heat sink is not
properly installed on the system board. Reseat the heat sink on the system board.
See the system board illustration for your computer (for the Dell Precision 650
computer, see "System Board Components" or for the Dell Precision 450
computer, see "System Board Components."
ALERT! COVER WAS PREVIOUSLY OPENED — The computer cover was
opened. Enter system setup and reset the Chassis Intrusion option.
ALERT! CPU 0 FAN FAILURE — The cooling fan for microprocessor 0 is
not installed, has failed, or is not properly connected to the system board. Ensure
that the cooling fan is properly installed and working. Also, ensure that the
microprocessor airflow shroud is properly installed. See "Microprocessor Airflow
Shroud"
ALERT! CPU 1 FAN FAILURE — The cooling fan for microprocessor 1 is
not installed, has failed, or is not properly connected to the system board. Ensure
that the cooling fan is properly installed and working. Also, ensure that the
microprocessor airflow shroud is properly installed. See "Microprocessor Airflow
Shroud."
To Next Page
Loading...
