198 Solving Problems
www.dell.com | support.dell.com
THE FILE BEING COPIED IS TOO LARGE FOR THE DESTINATION
DRIVE — The file that you are trying to copy is too large to fit on the disk. Try
copying the file to a blank disk or using a larger-capacity disk.
TIME-OF-DAY CLOCK STOPPED — The battery might be dead. Enter system
setup and correct the date or time. If the problem persists, see "Contacting Dell".
See "Battery Problems" for additional troubleshooting suggestions.
TIME-OF-DAY NOT SET — The time or date stored in system setup does not
match the computer clock. Enter system setup and correct the Date and Time
options.
TIMER CHIP COUNTER 2 FAILED — A chip on the system board might be
malfunctioning. Run the Dell Diagnostics.
UNEXPECTED INTERRUPT IN PROTECTED MODE — The keyboard
controller might be malfunctioning, or a memory module might be loose. Run
the Dell Diagnostics.
WARNING: DELL'S DISK MONITORING SYSTEM HAS DETECTED THAT
DRIVE [0/1] ON THE [PRIMARY/SECONDARY] EIDE CONTROLLER IS
OPERATING OUTSIDE OF NORMAL SPECIFICATIONS. IT IS ADVISABLE
TO IMMEDIATELY BACK UP YOUR DATA AND REPLACE YOUR HARD
DRIVE BY CALLING YOUR SUPPORT DESK OR DELL — During initial
start-up, the drive detected possible error conditions.
• When your computer finishes booting, immediately back up your data and
replace your hard drive.
• If no replacement drive is immediately available and the drive is not the only
bootable drive, enter system setup and change the appropriate drive setting to
None. Then remove the drive from the computer.
WRITE FAULT — The operating system cannot write to the floppy or hard
drive. See "Floppy drive problems" or "Hard drive problems" for troubleshooting
suggestions.
WRITE FAULT ON SELECTED DRIVE — The operating system cannot write
to the floppy or hard drive. See "Floppy drive problems" or "Hard drive problems"
for troubleshooting suggestions.
To Next Page
Loading...
