66 Advanced Features
www.dell.com | support.dell.com
THE INTEGRATED STRIPE VOLUME FAILS — The POST displays Failed
instead of Optimal.
1 Ensure that the SCSI cable is properly attached to each hard drive and to the
system board.
2 Ensure that the power cable is connected to each hard drive.
3 Ensure that the stripe volume drives have not been moved.
For additional assistance, see "Contacting Dell".
NOTICE: The following procedure may delete all the information that is
currently on your hard drives.
If the integrated stripe volume contains the operating system and the
computer does not boot:
1 Press <Ctrl><a> during system startup when the following message
appears:
Press Cntl-A to start LSI Logic Configuration
Utility.
2 Access the Array Disk menu
3 Delete the integrated stripe volume.
If the BIOS recognizes all SCSI hard drives, enter the configuration utility and
recreate the intergrate stripe volume.
If one or more the hard drives is not recognized by the BIOS or is the
configuration utility does not allow the selection of one or more of the hard
drives:
1 Replace the defective hard drive(s).
2 Enter the configuration utility and recreate the integrated stripe volume.
To Next Page
Loading...
