Dell Pro 16 Plus - Display Back Cover; Removing the Display Back Cover

Figure 39. Installing the camera moduledisplay cable
Steps
1. Align and place the camera module into the slot on the display back cover.
2. Connect the camera module cable to the connector on the camera module.
3. Adhere the tape to secure the camera cable to the camera.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the 5G WWAN card
5. Install the base cover.
6. Install the SIM card.
7. Follow the procedure in After working inside your computer
Display back cover
Removing the display back cover
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the SIM card.
3. Remove the base cover.
4. Remove the 5G WWAN card
5. Remove the display assembly.
6. Remove the display bezel.
7. Remove the display panel.
Removing and installing Field Replaceable Units (FRUs)
87