14. Remove the Keyboard.
15. Remove the display assembly.
About this task
NOTE: When replacing the palm-rest assembly, transfer the dummy SIM filler to the new palm-rest assembly.
The following image indicates the location of the palm-rest assembly and provides a visual representation of the removal
procedure.
Figure 61. Removing the palm-rest assembly
Steps
Remove all the components mentioned in the pre-requisites to get the palm-rest assembly.
NOTE: Do not remove the palm-rest from the touchpad assembly.
NOTE: Battery-support bracket and the keyboard-support frame must be removed from the palm-rest assembly.
Installing the palm-rest assembly
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
Removing and installing Field Replaceable Units (FRUs)
113
To Next Page
Loading...
