EasyManua.ls Logo

Dell S6000–ON - Page 267

Dell S6000–ON
1080 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1. Configure ToR- and FCF-facing interfaces as auto-upstream ports.
2. Configure server-facing interfaces as auto-downstream ports.
3. Configure a port to operate in a configuration-source role.
4. Configure ports to operate in a manual role.
1. Enter INTERFACE Configuration mode.
CONFIGURATION mode
interface type slot/port/subport
2. Enter LLDP Configuration mode to enable DCBx operation.
INTERFACE mode
[no] protocol lldp
3. Configure the DCBx version used on the interface, where: auto configures the port to operate using
the DCBx version received from a peer.
PROTOCOL LLDP mode
[no] DCBx version {auto | cee | cin | ieee-v2.5}
cee: configures the port to use CEE (Intel 1.01).
cin: configures the port to use Cisco-Intel-Nuova (DCBx 1.0).
ieee-v2.5: configures the port to use IEEE 802.1Qaz (Draft 2.5).
The default is Auto.
4. Configure the DCBx port role the interface uses to exchange DCB information.
PROTOCOL LLDP mode
[no] DCBx port-role {config-source | auto-downstream | auto-upstream |
manual}
auto-upstream: configures the port to receive a peer configuration. The configuration source is
elected from auto-upstream ports.
auto-downstream: configures the port to accept the internally propagated DCB configuration
from a configuration source.
config-source: configures the port to serve as the configuration source on the switch.
manual: configures the port to operate only on administer-configured DCB parameters. The port
does not accept a DCB configuration received from a peer or a local configuration source.
The default is Manual.
5. On manual ports only: Configure the PFC and ETS TLVs advertised to DCBx peers.
PROTOCOL LLDP mode
[no] advertise DCBx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-reco |
pfc] [ets-conf | ets-reco | pfc]
ets-conf: enables the advertisement of ETS Configuration TLVs.
ets-reco: enables the advertisement of ETS Recommend TLVs.
pfc enables: the advertisement of PFC TLVs.
The default is All PFC and ETS TLVs are advertised.
Data Center Bridging (DCB)
267

Table of Contents

Other manuals for Dell S6000–ON

Related product manuals