Dell S6000–ON - Page 268

NOTE: You can configure the transmission of more than one TLV type at a time; for example,
advertise DCBx-tlv ets-conf ets-reco. You can enable ETS recommend TLVs (ets-reco)
only if you enable ETS configuration TLVs (ets-conf).
To disable TLV transmission, use the no form of the command; for example, no advertise DCBx-
tlv pfc ets-reco.
6. On manual ports only: Configure the Application Priority TLVs advertised on the interface to DCBx
peers.
PROTOCOL LLDP mode
[no] advertise DCBx-appln-tlv {fcoe | iscsi}
• fcoe: enables the advertisement of FCoE in Application Priority TLVs.
• iscsi: enables the advertisement of iSCSI in Application Priority TLVs.
The default is Application Priority TLVs are enabled to advertise FCoE and iSCSI.
NOTE: To disable TLV transmission, use the no form of the command; for example, no
advertise DCBx-appln-tlv iscsi.
For information about how to use iSCSI, refer to iSCSI Optimization
To verify the DCBx configuration on a port, use the show interface DCBx detail command.
Configuring DCBx Globally on the Switch
To globally configure the DCBx operation on a switch, follow these steps.
1. Enter Global Configuration mode.
EXEC PRIVILEGE mode
configure
2. Enter LLDP Configuration mode to enable DCBx operation.
CONFIGURATION mode
[no] protocol lldp
3. Configure the DCBx version used on all interfaces not already configured to exchange DCB
information.
PROTOCOL LLDP mode
[no] DCBx version {auto | cee | cin | ieee-v2.5}
• auto: configures all ports to operate using the DCBx version received from a peer.
• cee: configures a port to use CEE (Intel 1.01). cin configures a port to use Cisco-Intel-Nuova
(DCBx 1.0).
• ieee-v2.5: configures a port to use IEEE 802.1Qaz (Draft 2.5).
The default is Auto.
NOTE: To configure the DCBx port role the interfaces use to exchange DCB information, use
the DCBx port-role command in INTERFACE Configuration mode (Step 3).
4. Configure the PFC and ETS TLVs that advertise on unconfigured interfaces with a manual port-role.
PROTOCOL LLDP mode
268
Data Center Bridging (DCB)