Dell S6000–ON - Page 745

192.162.2.0/24
[120/1] via 29.10.10.12, 00:01:21, Fa 1/4
192.162.2.0/24 auto-summary
192.161.1.0/24
[120/1] via 29.10.10.12, 00:00:27, Fa 1/4
192.161.1.0/24 auto-summary
192.162.3.0/24
[120/1] via 29.10.10.12, 00:01:22, Fa 1/4
192.162.3.0/24 auto-summary
Dell#show ip rip database
Total number of routes in RIP database: 978
160.160.0.0/16
[120/1] via 29.10.10.12, 00:00:26, Fa 1/49
160.160.0.0/16 auto-summary
2.0.0.0/8
[120/1] via 29.10.10.12, 00:01:22, Fa 1/49
2.0.0.0/8 auto-summary
4.0.0.0/8
[120/1] via 29.10.10.12, 00:01:22, Fa 1/49
4.0.0.0/8 auto-summary
8.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 1/49
8.0.0.0/8 auto-summary
12.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 1/49
12.0.0.0/8 auto-summary
20.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 1/49
20.0.0.0/8 auto-summary
29.10.10.0/24 directly connected,Fa 1/49
29.0.0.0/8 auto-summary
31.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 1/49
31.0.0.0/8 auto-summary
192.162.2.0/24
[120/1] via 29.10.10.12, 00:01:21, Fa 1/49
192.162.2.0/24 auto-summary
192.161.1.0/24
[120/1] via 29.10.10.12, 00:00:27, Fa 1/49
192.161.1.0/24 auto-summary
192.162.3.0/24
[120/1] via 29.10.10.12, 00:01:22, Fa 1/49
192.162.3.0/24 auto-summary
To disable RIP globally, use the no router rip command in CONFIGURATION mode.
Configure RIP on Interfaces
When you enable RIP globally on the system, interfaces meeting certain conditions start receiving RIP
routes.
By default, interfaces that you enable and configure with an IP address in the same subnet as the RIP
network address receive RIPv1 and RIPv2 routes and send RIPv1 routes.
Assign IP addresses to interfaces that are part of the same subnet as the RIP network identified in the
network command syntax.
Routing Information Protocol (RIP)
745