Delta Electronics DVP15MC11T User Manual

DVP15MC11T Operation Manual
10
DVP15MC11T is a motion controller which is developed in compliance with CANopen DSP402 motion control
protocol and the motion control instructions defined as function blocks are needed for it.
The motion control instructions for the MC module are based on the technical specifications of motion control
function blocks in the PLCopen.
Below is the introduction of what need be known about while the motion instructions are used.
10.1 EN and ENO
When one instruction which is used has EN and ENO and EN is FALSE (0), the function defined by instruction
will not be performed and the output values of the instruction will not be refreshed. On the contrary, the
function defined by the instruction will be performed and the output values will be refreshed if EN is TRUE (1).
The output of ENO and the input of EN keep consistent with each other. ENO changes to TRUE while EN is
TRUE. ENO changes to FALSE while EN is FALSE.
For the FB instruction, the instruction execution will continue as its EN changes from TRUE to FALSE after
being executed. But the output values of the FB instruction will not be refreshed.
10-2

Delta Electronics DVP15MC11T Specifications

General

Brand	Delta Electronics
Model	DVP15MC11T
Category	Controller
Language	English