Chapter 8 Hardware Configuration
NTP
Click NTP to synchronize the real-time clock in the CPU module to an NTP server. Please refer to related documents
or manuals for more information about NTP.
Select the
NTP Client Function Enable
check box, and then set the related parameters.
Select
NTP Client Function Enable
to enable this function.
Set the IP address for an
NTP server
. The CPU module corrects its internal time by connecting periodically to the
server.
Update Cycle
: Set a time interval for correcting the time in the CPU module. If the interval is thirty minutes, the CPU
module connects to the NTP server every thirty minutes.
Select a time zone in the
Time Zone
list.
Email
Click
Email
to set the email-related functions. The system sends email to the set email address after you enable the
email function. You can set up to four sets of conditions for sending email to up to four groups of email addresses.
Select
Email Function Enable
to enable this function.
Set an IP address for the
SMTP server
. Set the
Port
of SMTP server and set the sender’s
Local Email
address.
Type the
Mail Subject
to appear at the start of the subject of every email.
To Next Page
Loading...
Need help?
General
