Chapter 10 CANopen Function and Operation
IFD9503
The IFD9503 gateway converts CANopen
to Modbus, and connects a device (with
an RS-232 or RS-485 interface) that
conforms to the standard Modbus
protocol to a CANopen network. You
can connect up to 15 devices.
DVPCP02-H2
The CANopen slave module is connected
to the right side of an EH2 series PLC. It
can connect the EH2 series PLC to a
CANopen network.
IFD6503
This analyzes CANopen network data,
and has ports both ends for a CAN
interface and a USB interface. Use it to
monitor CAN network data, or allow CAN
nodes to transmit the data. The product is
used with the Netview Builder software.
ASD-A2-xxxx-M
servo driver
This servo driver has a built-in CANopen
interface. It controls positioning, speed,
and torque.
VFD-C2000/CP20
00/C200 series
AC motor drives
This AC motor drive has a built-in
CANopen function, controls positioning,
speed, and torque. For the
C2000/CP2000 series AC motor drives,
you must purchase a CMC-COP01 to
provide the CAN interface. Only the C200
series AC motor drive has the built-in
VFD-EC series
AC motor drive
The EC series AC motor drive has a
built-in CANopen interface. It controls
speed and torque.
To Next Page
Loading...
