Input the type of components connected to the digital input terminals
1
lrl[t)
Use the Q (left) and Q (right) buttons to set the type of device connected to the COAXIAL input (COAXIAL)
b
terminal.
(Initial)
:-..
. . . .
. . . .
1
*-. yi q :...:
:... : : $..,
.“.. :...: i : ( .:
;...‘1./! I...’
ICB((DUD((;;.i~(I:!CR_I.I(::oR((OFF(
6 Q
(left) button
(right) button
l Select “OFF” if nothing is connected.
Press the SELECT or (3 (down) button to switch the optical input 1 (OPT I) setting.
2
Use the”%3 (left) and Q (right) buttons to set the type of device connected to the OPTICAL input (OPTICAL)
terminal.
(Initial)
.: .-* -:- : :
: : ..:
ICD((C!VD((TI..~IlllcR:Z((CBR((OFFI
.i. ::..r
i-i I:::: “[” 4
. . . . . : : .I.
1 i i
. a..
6 El
(left) button
(right) button
l Select “OFF” if nothing is connected.
Press the SELECT or Q (down) button to switch the optical input 2 (OPT 2) setting
3
Use the a (left) and Q (right) buttons to set the type of device connected to the OPTICAL input (OPTICAL)
terminal.
(Initial)
.I .i :-: i”‘: “I” .“>
.i. .I. .
iJ i”’ : .:I..
:-. i”.. p
i . . . . I...: i’:::
~I(l::,u::!((:..iiIIUC:i-I:!Ili..!.l:R:,’~III:iFF
a G
(left) button
(right) button
l Select “OFF” if nothing is connected.
Press the SELECT or I3 (down) button if you want to start the settings over front the beginning.
NOTE: PHONO, TUNER and V. AUX cannot be selected.
1
ISYSTEM
Press the SYSTEM button to finish system set up.
This completes the system setup operations. Once the system is set up, there is no need to make the settings again unless other components
or speakers are connected to or the speaker layout is changed.
21
To Next Page
Loading...
Need help?
General
Weight and Dimensions
