1
Select the input source.
1 Playback with a digital input 1
@ Select an input source set to digital (COAXIAL/OPTICAL)
(see page 21).
EX:
DVDNDP.
%
(Main unit1
(Remote control unit)
@ Set the input mode to “AUTO” or DTS
INPUT MODE
INPUT MODE
(Main unit1
(Remote control unit)
Select the Dolby/DTS Surround mode
SUz%:ND
%
R3mote control unit)
When performing this operation from the main unit’s panel,
press SURROUND MODE, then turn SELECT knob and select
“DOLBY/DTS”.
l The following appears on the display. (DOLBY PL II, PRO
LOGIC, DOLBY DIGITAL, DTS SURROUND)
(Man unit)
1
2
4,5, 6, 7
-4, 5, 6, 7
3
Play a program source with the onm , m mark
DIOITAL
DO
DIGpu
l The Dolby Digital indicator lights when
l The DTS indicator lights when playing
-;+ Light
playing Dolby Digital sources. DTS sources.
Set the surround parameter according to the source.
First, press the SURROUND button.
NOTE: Please make sure the “AUDIO”
position of the slide switch on the
remote control unit.
(Remote control unft)
I
:-. ‘i’ 1.. 1 1:::’ k:.i f:-
i .,.. .I. i ‘ii .... j ii i
1:::’ f.‘;
:...: i”” :....
I . . . . :.:.:
i...i i”’ *
. .
I
The CINEMA EQ mode can be set directly using the main
unit’s CINEMA EQ button.
l CINEMA EQ mode turns on and off
each times the CINEMA EQ button
is pressed.
(Main unit)
(Remote control unlt)
Use a (left) and Q (right) buttons to
set the CINEMA EQ.
(Initial)
a Q
(left) button (right) button
33
To Next Page
Loading...
Need help?
General
Weight and Dimensions
