EasyManuals Logo

Denon AVR-1802 Operating Instructions

Denon AVR-1802
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
0
13 SURROUND
l Before playing with the surround function, be sure to use the test tones to adjust the playback level from each speakers. This adjustment can
be performed from the remote control unit, as described below.
l The adjustment with the test tones is only effective in the DOLBY/DTS SURROUND modes.
The adjusted playback levels for the different surround modes are automatically stored in the memory of each surround modes.
1
Set the DOLBY/DTS SURROUND (Dolby Pro Logic II or Dolby
Digital or DTS) modes.
(Man unit)
(Remote control untt)
Press T. TONE button.
IT.TONEI
RETUR
-3
(Remote control wt)
Test tones are output from the
different speakers. Use the channel
El
volume adjust buttons to adjust so
Ob
7
that the volume of the test tones is
the same for all the speakers.
(Remote control unit)
NOTE: Please make sure the “AUDIO” position of the slide
switch on the remote control unit.
3
After completing the adjustment, press T. TONE button again.
RETUR
%
(Remote control umt)
l After adjusting using the test tones, adjust the channel levels either according to the playback sources or to suit your tastes, as described below.
1
Select the speaker whose level you want to adjust.
.
CH “In
y& zq$
(Main unit)
(Remote control unit)
1010 . .
0000~0~
c3 0
The channel switches as shown below each time the button
Yl=
-
-
is pressed.
-pvJ-
I
NOTE: Please make sure the “AUDIO” position of the slide
switch on the remote control unit.
2-
2
Adjust the level of the selected speaker.
l-
(Main unit)
(Remote control unit)
% The level of the selected speaker can be adjusted within
the range of +I2 to -12 dB using the SELECT (up and
down) buttons.
30

Table of Contents

Other manuals for Denon AVR-1802

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-1802 and is the answer not in the manual?

Denon AVR-1802 Specifications

General IconGeneral
Speakers connectivity type-
Receiver typeSurround
Frequency range10 - 100000 Hz
Audio output channels5.1 channels
Signal-to-Noise Ratio (SNR)100 dB
Total Harmonic Distortion (THD)0.7 %
Power output per channel (1KHz@6 Ohm)115 W
Power output per channel (20-20KHz@8 Ohm)80 W
AC input voltage120 V
AC input frequency60 Hz
EqualizerYes
Audio decodersDTS, Dolby Digital, Dolby Pro Logic II
3DNo
AM band range520 - 1710 kHz
FM band range87.5 - 107.9 MHz
Supported radio bandsAM, FM
HDMI in0
Composite video in5
S-Video inputs quantity4
Digital audio coaxial in1
Digital audio optical in3
Weight and Dimensions IconWeight and Dimensions
Depth417 mm
Width434 mm
Height171 mm
Weight10900 g

Related product manuals