cl
11 REMOTE CONTROL UNIT
Z-b-
I
2-a-
-
NOTE:
DENON remote-controllable audio components can be controlled using this unit’s remote control unit.
Note that some components, however, cannot be operated with this remote control unit.
1
Set the slide switch to the position for the component to
be operated (CD or MD/CDR).
2
Use the buttons shown below to operate the audio component.
For details, refer to the respective component’s manual.
a. For CD player and MD/CD recorder
-,m
n
b
w,w
II
DISC SKIPi
b. For tape deck (TAPE)
II
Y A”X “CR-1 “CR.* TVIDBS
I4100[71
c. For TUNER
4
H
n
b
4
SHIFT
CHANNEL
(+, -4
Manual search (reverse and forward)
stop
Play
Auto search
Pause
Switch discs (for CD changers only)
Rewind
Fast-forward
stop
Forward play
Reverse play
Switch preset channel range
Preset channel up/down
l Tape deck (TAPE) and tuner can be operated when the switch is at “AUDIO” position.
22
-2
DENON components can be operated by setting the preset n$amory for MD or CDR.
Operation in not possible for some models.
1
Set the slide switch to “MD/CDR”.
2
Holding in the PLAY 0) button, press the button for the
components you want to set. (Refer to table I.)
Table 1: Combinations of Personal System
Codes
NOTE:
.
.x
can only be preset for either the MD or the CDR.
reset codes set upon shipment from the factory and when reset.
To Next Page
Loading...
