[2] Listening over headphones
1
Connect the headphones to the
PHONES
PHONES jack of the front panel.
2
Press SPEAKER A or B to turn the
0~~~~~~~0
speaker off.
&&
b
Cautions:
l No sound is produced from the headphones when speakers A or B
are turned on.
l When an external power amplifier is connected to the front preout
jacks, turn off the external power amplifier’s speaker switch.
[31 Turning the sound off temporarily (muting)
1
Use this to turn off the audio output
temporarily.
MUTING
Press MUTING.
9% Cancelling MUTING mode.
Press the MUTING button again.
%
Muting mode will also be cancelled
when MASTER VOL is adjusted up
or down.
[41 Combining the currently playing sound with the desired image
1
Simulcast playback
Use this switch to monitor a
VIDEOSELECT
IVIDEO sELEcTI
video source other than the
audio source.
Press VIDEO SELECT
repeatedly until the desired
source appears on the
(Main unit1
IRemote control unft)
display.
% Cancelling simulcast playback.
l Select “SOURCE” using the video select button.
l Switch the program source to the component connected to
the video input.
[51 Checking the currently playing program source, etc.
1
Front panel display
l Descriptions of the unit’s
operations are also
STATUS
displayed on the front
panel display. In addition,
the display can be
b%
switched to check the
unit’s operating status
(Main unit)
(Remote control unft)
while playing a source by
pressing STATUS.
2
Using the dimmer function
l Use this to change the brightness of the
DlMMER
display.
The display brightness changes in four
steps (bright, medium, dim and off) by
pressing the main unit’s DIMMER
repeatedly.
FL
IMan unit)
% The brightness changes in 3 steps each time the button is
pressed, and finally the display turns off.
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
-I
1
28
To Next Page
Loading...
Need help?
General
Weight and Dimensions
