Tqyj$
Press SURROUND or a (down) button to switch to the D.COMP. setting.
IRemote control unit)
5
=I,]
Use Q (left) and m (right) buttons to set the D. COMP.
b
(Initial)
i-.
(Remote control unit)
i...’ ::
I . . . . :...I
:-. I-: rt’l I:::: :: )-J I:::’ I:::
IC:ii-;p-pqIIHi:i:;HI
6
Q
(Remote control unit1
(left) button
(right) button
Press SURROUND or m (down) button to switch to the LFE setting.
NOTE:
This parameter is not displayed
during DTS playback.
6
[rl[,l
Use Q (left) and r3 (right) buttons to set the LFE level.
b
I
: :.... :....
. . . .
: :... :...
I . . . . i i . . . .
i...;
: :....
. . . . . s....
. . . . . . . ..I
i...’
(Remote control unit)
q&x
l The level can be adjusted in units of 1 dB from -10 to 0 dB.
(The level can be adjusted 1 dB at a time from 0 dB to +I0 dB during DTS play.)
Set to the desired level according to the speaker systems being used and the source to be played.
(Remote control unit1
Press SURROUND or t3 (down) button to switch to the default setting.
To reset the settings to the factory defaults, use a (left) and Q (right) buttons to display “Yes”.
:... :.... ,.... . . . . . i i i ..!”
)...I (::-* I”’ )-I 1.J I.... 1
i.i . . . . . !..I
(Remote control unit)
I
I
El
Q
(left) button
(right) button
Press SURROUND or m (down) button to switch to the CINEMA EQ. setting.
I
I
NOTE:
l When making parameter settings, the display will return to the regular condition several seconds after the last button was pressed and the
setting will be completed.
Surround parameters @
CINEMA ED (Cinema Equalizer):
The Cinema EQ function gently decreases the level of the extreme high frequencies, compensatingpr overly-bright sounding motion picture
soundtracks, Select this function if the sound from the front speakers is too bright.
This function only works in the Dolby Pro Logic, Dolby Digital and DTS Surround modes.
D.COMP. (Dynamic Range Compression):
Motion picture soundtracks have tremendous dynamic range (the contrast between very soft and very loud sounds). For listening late at night,
or whenever the maximum sound level is lower than usual, the Dynamic Range Compression allows you to hear all of the sounds in the
soundtrack (but with reduced dynamic range). (This only works when playing program sources recorded in Dolby Digital.) Select one of the four
parameters (“OFF”, “LOW ,
” “MID” (middle) or “HI” (high)). Set to OFF for normal listening.
LFE (Low Frequency Effect):
Program source and adjustment range
1. Dolby Digital: -10 dB to 0 dB
2. DTS Surround: 0 dB to +I0 dB
% When Dolby Digital encoded software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct Dolby Digital
playback.
I When DTS encoded movie software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct DTS playback.
% When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to -10 dB for correct DTS playback.
34
To Next Page
Loading...
Need help?
General
Weight and Dimensions
