DGH TECHNOLOGY SCANMATE FLEX - Page 25

25
†This command may be executed through voice control. Refer to the B-Scan and UBM Voice Controls secon.
9. IF the soware is congured as Scan and Record (Preferences > B-Scan Page), the soware
will begin recording as soon as the scan is started.
IF the soware is congured as Scan Only (Preferences > B-Scan Page), the soware will
begin scanning, but will not start or stop recording unl prompted.
To Start / Stop recording: - Click the [RECORD] buon; or
- Press the Enter Key (keyboard); or
- Press the Right Foot Pedal (Double Pedal accessory)
NOTE: Once the soware has recorded the number “Video Buer Frames” specied in the
Operator Preferences, the scan will begin to overwrite itself.
10. To Stop scanning†: - Click the [STOP SCAN] buon; or
- Press the Space Bar (keyboard); or
- Press the Foot Pedal (Single Pedal accessory); or
- Press the Le Foot Pedal (Double Pedal accessory).
11. Review frames recorded during the exam by pressing ← and → on the keyboard or by
moving the slider (below video display). The exam video can also be replayed.
12. To save images†, click the [SAVE IMAGE] buon (upper right-hand corner) or select File >
Save > B-Scan Image.
To save videos†, click the [SAVE VIDEO] buon (upper right-hand corner) or select File >
Save > B-Scan Video†.
NOTE: The UBM transducer should be allowed to completely air dry before storage.