Need help?Do you have a question about the DGH TECHNOLOGY SCANMATE FLEX and is the answer not in the manual?
Details potential hazards like explosion, electrical shock, contamination, and burns.
Advises on handling sharp objects and disconnecting the device for maintenance.
Specifies approved applications and conditions where the device should not be used.
Covers prescription device status and required operator qualifications.
Advises on minimizing ultrasound exposure according to the ALARA principle.
Guides through initial connection of probes, cables, and software installation.
Steps for patient positioning, selecting probe, and initial scan settings.
Instructions on initiating scans and recording video based on preferences.
Procedures for stopping scans and saving images or videos.
Covers warnings, probe cover usage, and patient positioning for UBM scans.
Details selecting probe parameters and starting the UBM scan.
Safety precautions, cleaning, and patient setup for contact A-scan.
Steps for applying the probe, adjusting sensitivity, and starting the scan.
Guidance on probe alignment, coupling, and minimizing corneal indentation.
Safety, cleaning, and immersion shell setup for immersion A-scan.
Steps for probe insertion, saline injection, and starting the scan.
Guidance on probe alignment, coupling, and achieving proper alignment.
Inputting patient measurements and lens data for IOL calculations.
Using the calculator for patients with prior corneal refractive surgery.
Steps for choosing patient, doctor, and verifying pre-operative data.
Entering A-scan averages, corneal refractive index, and desired Rx.
Using default or personalized constants and selecting IOL formulas.
Steps to access the post-refractive calculator via the IOL Calculator Screen.
Entering pre- and post-surgical refractive information and K values.
Process for calculating Kcorr using various methods like History Derived.
Criteria for choosing valid patient data for calculating personalized constants.
Steps for performing calculations and adding results to the constants table.
Table of compatible disinfectants, concentrations, and probe compatibility.
Procedures for cleaning and disinfecting A-scan probes and immersion shells.
Steps to verify A-scan calibration using a standardized polystyrene test block.
Information on how to get service, repairs, and customer support.
Solutions for issues connecting to the DGH database server.
Troubleshooting steps for USB connectivity problems with the device.
Solutions for failure to acquire A-scan measurements or measurement errors.
Troubleshooting steps for poor quality B-scan images and video.
Resolving issues with patient data loading and probe key expiration.
General| Category | Diagnostic Equipment |
|---|---|
| Power Supply | Rechargeable battery |
| Display | LCD |
| Communication Interface | USB |
| Alarms | Audible and visual alarms |
| Compliance | CE |
To Next Page