DGH TECHNOLOGY SCANMATE FLEX - Scan Voice Controls

35
A-SCAN VOICE CONTROLS
ENABLING VOICE CONTROL
Voice control can be enabled/disabled through the Preferences > System menu. Voice control
can be congured to begin upon pressing the [ENTER] key or by a verbal command of “Hey
Flex”. Voice control sensivity can be adjusted in this menu as well.
NOTE: To use the voice control feature, the computer running the Scanmate Flex soware
must have a connected (or integrated) microphone that is enabled.
NOTE: If the [ENTER] key is not congured to iniate a voice command, pressing it while on
the A-Scan Screen will automacally save a measurement le.
VOICE COMMANDS
The following verbal commands are recognized by the Scanmate Flex soware while performing
an A-Scan. To issue a command, the user must rst say “Hey Flex” or press the [ENTER] key
(depending upon System Conguraon).
USER
VERBAL COMMANDS
FLEX
AUDIBLE RESPONSE
FLEX
COMMAND EXECUTED
“Hey Flex” Tone: Double-Beep Voice control acvated. The soware
is ready to receive verbal commands.
“Start Scan” Verbal: “Starng Scan” The A-scan will start.
“Stop Scan” * Verbal: “Scan Stopped” The A-scan will stop.
“Change Eye” Verbal: “Eye changed to
OD/OS.”
The eye being scanned is changed.
The audible response will state if OD
or OS is being scanned.
“Save Measurements” Verbal: “Measurements Saved” The currently displayed frame is
saved.
“Save Video” Verbal: “Video Saved” The currently displayed video is saved.
“Open File” N/A A window is opened showing
A-Scan measurements and videos for
the currently loaded paent.
“Yes” * N/A Selects ‘Yes’ for a dialog box prompts.
“No” * N/A Selects ‘No’ for a dialog box prompts.
* Indicates a command that DOES NOT require “Hey Flex” or an [ENTER] key press to
be iniated.