Why can't I send files from my DGH 55B Measuring Instruments to my PC/printer?
If your DGH Measuring Instruments device won't send files to a PC or printer, the issue might be due to several reasons: * Bluetooth might not be enabled. * The devices might not be properly paired. * The COM settings could be incorrect. To resolve this, enable the Bluetooth module, pair the devices, and adjust the COM settings accordingly.
What to do if DGH 55B Measuring Instruments shows ‘Remote Device Not Found’ error?
If the DGH Measuring Instruments shows a 'Remote Device Not Found' error when sending measurements to the software, it's likely that pairing hasn't been established. To fix this, pair the devices and then add the device to the software's device list.
Why does my DGH Measuring Instruments have black boxes on the screen?
If black boxes appear across the top half of the screen on your DGH Measuring Instruments, it could be due to: * Bad battery contact. * Dead batteries. To solve this, try cleaning the battery contacts or replacing the batteries.
How to fix a DGH 55B device that will not turn on?
If your DGH Measuring Instruments won't turn on, the cause might be dead batteries. Replace the batteries to solve this.
What to do if DGH 55B Measuring Instruments screen is blank?
If the DGH Measuring Instruments screen is blank, it might be in Sleep Mode. Press the PWR button to exit Sleep Mode.
What to do if DGH 55B Measuring Instruments screen is on, but not taking measurement?
If the DGH Measuring Instruments screen is on but not taking measurements, it might be in Standby Mode, indicated by a blinking black cursor in the upper left-hand corner. Press the PWR button to exit Standby Mode.
How to find my device on Pachmate 2 for DGH Measuring Instruments?
If you cannot find the correct device on the Pachmate 2 when trying to export/print measurements from your DGH Measuring Instruments, it's likely that pairing hasn't been established. Clear all pairing and re-pair with your preferred device.
Why is my DGH Measuring Instruments measurement cycle slow?
A slow measurement cycle on your DGH Measuring Instruments could be due to: * A dented or scratched probe tip. * The ‘Auto Rep Delay’ configuration. Consider replacing the probe or adjusting the configuration to solve this.
How to initiate CalBox mode on DGH Measuring Instruments?
To initiate CalBox mode on your DGH Measuring Instruments, ensure the device is off, then hold down the DEL key and press the PWR key. The device should start in CalBox mode.
General| Brand | DGH |
|---|---|
| Model | 55B |
| Category | Measuring Instruments |
| Language | English |
To Next Page