Page 26 of 87 DGH 55B-INS-OMENG Rev: 3
10. Patient Modes
10.1 Single Patient Mode
NOTE: Single Patient Mode is available on all Pachmate 2 devices; however exporting
measurements from the device is only available with Bluetooth
®
module option installed.
By default, every time the Pachmate 2 is turned on, it is in
Single Patient Mode. Single Patient Mode allows the user
to start taking measurements immediately. Single Patient
Mode is indicated by a blank space on the lower left-hand
side of the screen.
Once the user completes taking measurements for both the right and left eye, the measurements
must be cleared before a new measurement group can be initiated. The device can only
remember a single patient’s measurements while operating. Therefore it is necessary to either
write down or export the measurements.
NOTE: In Single Patient Mode the device can take either Continuous Averaging or Mapping
measurements. However, if the Measurement Mode is changed it will clear the measurements for
all patients stored in memory.
To Next Page
Loading...