Page 28 of 87 DGH 55B-INS-OMENG Rev: 3
10.2 Multi-Patient Mode
NOTE: Use of Multi-Patient Mode is only available with a Bluetooth
®
enabled device. This
includes transferring data and storing data in Non-Volatile memory.
Multi-Patient Mode allows the user to access the memory
of the device for storing patient measurements. Multi-
Patient mode is indicated by a number (P01-P20) being
displayed in the bottom left-hand corner of the screen.
The memory is capable of storing information for 20 patients. The user selects a number (P01-
P20) and takes measurements for the right and left eye. When measurement is complete, the user
presses the CFG key and all results are recorded and can be retrieved at a later time.
The user can also use the DGH Connect Software (See section 11) to enter patient identification
information before taking measurements.
NOTE: In Multi-Patient Mode the device can take either Continuous Averaging or Mapping
measurements. However, if the Measurement Mode is changed it will clear the measurements for
all patients stored in memory.
To Next Page
Loading...