Page 51 of 87 DGH 55B-INS-OMENG Rev: 3
13.5 Bluetooth
®
Parameters
These are the Bluetooth
®
operation parameters. If the Pachmate 2 has a Bluetooth
®
module
installed, they will be accessible when the Bluetooth
®
parameter is enabled. Only Devices with a
Bluetooth
®
Wireless Technology Logo printed on the front have a module installed.
NOTE: To access these parameters, enter the Configuration Menu by pressing the CFG key.
Press the ENT key repeatedly to navigate through the menu. See section 13.1
13.5.1 Bluetooth (default On) determines if the
Bluetooth
®
module is enabled or disabled. This
must be set to ‘On’ to connect devices or transfer
files. Press the or key to change the value.
• When the Bluetooth
®
wireless module is enabled, a logo will appear in the upper left-
hand corner.
13.5.2 Send Meas To determines which device the
Pachmate 2 will transmit records to. If there are no
devices paired with the Pachmate 2, the screen will
display ‘---None---‘.
• If the Pachmate 2 is paired to one or more
devices, the screen will display:
o NAME is the name of the device that will
receive the records.
o #
A
is the list number of the device shown.
o #
B
is the total number of devices paired with the Pachmate 2. Up to 5 devices can
be paired at a time.
o Send → indicates that pressing the OD key will cause the Pachmate 2 to transmit
measurements to the currently displayed device.
13.5.3 When Add PC/Printer is displayed, the device is
in Bluetooth
®
discoverable mode. This is a
necessary mode for pairing Bluetooth
®
devices. See
section 14 for information on device pairing.
To Next Page
Loading...