Page 25 of 87 DGH 55B-INS-OMENG Rev: 3
9.3 Sleep Mode
The device will automatically enter Sleep Mode if it has
been in Standby Mode for three minutes and there have
been no key presses. When entering Sleep Mode the
Pachmate 2 will display a ‘Powering Down’ message:
After the ‘Powering Down’ message, the display will go blank and the unit will appear to be off,
but all the measurements that were taken can still be retrieved.
To bring the device out of Sleep Mode, press the PWR key.
The unit will perform an internal test and display battery
status.
If there are no currently active measurements, the device
will show an empty measurement screen. If there are active
measurements, the Pachmate 2 will display:
• Press the key to clear all measurements.
Press the key to retrieve all measurements.
• After exiting Sleep Mode, the device will return to Measurement Mode.
9.4 Powering Down
The unit is powered down by pressing and holding the PWR key. The device will emit a beep
and turn off.
NOTE: If the device is powered down by the user, only measurements in memory will be stored.
See sections 10.1 and 10.2 for information on memory.
9.5 Checking Battery Power
Battery power will be displayed every time the device is
powered on. Battery power can also be checked at any time
by quickly pressing the ENT key.
To Next Page
Loading...