Page 43 of 87 DGH 55B-INS-OMENG Rev: 3
12.3.18 To clear all measurements for one or both eyes,
press the CLR key. The user will be prompted with
the ‘What To Clear?’ menu:
• The following selections affect the patient currently being measured.
o Selecting ‘All Current Meas’ clears all measurements of both the left and
right eye for the currently loaded patient.
o Selecting ‘OD Current Meas’ clears all measurements of the right eye for
the currently loaded patient.
o Selecting ‘OS Current Meas’ clears all measurements of the left eye for
the currently loaded patient.
o Selecting ‘Nothing (Exit)’ exits the menu without deleting anything.
• The other clearing options affect stored patient information or system configuration.
o Selecting ‘All Patients’ clears all identifying information and all
measurements for all patients. (Bluetooth
®
option only)
o Selecting ‘Paired Devices’ clears all paired devices from the device
memory. (Bluetooth
®
option only)
12.4 Viewing Date and Time
The Pachmate 2 can display the time and date on the screen to assist the operator in recording
when measurements are taken.
12.4.1 Press and hold the CLR key until the Time / Date
screen is displayed.
12.4.2 The Time / Date screen will be displayed until the operator presses the CLR key again.
The device will return to Measurement Mode.
• The user can configure how the date will be displayed. See section 13.4.5.
12.4.3 If the user is using a Bluetooth
®
enabled device to receive patient reports, the Time and
Date will be recorded with the measurements.
To Next Page
Loading...