DGH 55B - Page 27

87 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Page 27 of 87 DGH 55B-INS-OMENG Rev: 3

Fig 10.1.1 Single Patient Mode

Table of Contents

Table of Contents3
1 Introduction6
- General Device Description6
- Device Classification6
- Indications for Use6
2 Description of Symbols7
3 General Cautions and Warnings, Prescription Device Statement and Operator Qualifications8
- General Cautions and Warnings8
- Prescription Device Statement8
- Operator Qualifications8
4 Use of Ultrasound in Ophthalmic Measurement9
- Introduction to Ultrasound9
- Using Ultrasound to Ascertain Correct Probe Alignment9
- Ultrasonic Measurement10
- Proper Applanation for Takinga Measurement11
5 Ultrasonic Exposure and Intensities12
- Tissue Exposure to Ultrasound Energy12
- Ultrasonic Intensities12
- Biometric Measurement Capabilities13
6 Physical Description14
- Front View14
- Back View16
- Probe17
- Calibration Verification Box (Calbox)18
7 Probe Use and Indicators19
- Inserting and Removing the Probe19
- Holding the Device20
- Check Probe' Error Message21
- Plug in Probe' Error Message21
- PQF Failed' Error Message21
8 Verifying Pachmate 2 Calibration22
- Procedure for Verifying Calibration22
9 Power Modes24
- Measurement Mode24
- Standby Mode24
- Sleep Mode25
- Powering down25
- Checking Battery Power25
10 Patient Modes26
- Single Patient Mode26
- Multi-Patient Mode28
- Changing Patient Modes30
- Adding Patient Identification Information31
- Clearing Patient Information32
11 Measurement Modes33
- Continuous Averaging Measurement Mode33
- Mapping Measurement Mode34
- Changing Measurement Modes35
12 Taking Measurements36
- Power up Sequence36
- Measurement in Continuous Averaging Mode37
- Measurement in Mapping Mode40
- Viewing Date and Time43
13 Configuring the Pachmate 244
- Entering and Navigating the Configuration Menu44
- Parameters for Continuous Averaging Measurement Mode47
- Parameters for Mapping Measurement Mode48
- General Device Parameters49
- Bluetooth Parameters51
14 Configuring Bluetooth Connections53
- Enabling Bluetooth53
- Pairing with a Bluetooth Enabled Printer53
- Sending Measurements to a Bluetooth ® Enabled Wireless Printer55
- Pairing with a Bluetooth Enabled PC56
- Adding Com Ports59
- Sending and Receiving Information Via Bluetooth Connection to a PC60
- Recalling Paired Device Configuration61
- Clearing All Paired Bluetooth Devices62
15 Dgh Connect Software63
- Software Requirements63
- Installing the Software64
- Configuring the Software65
- Adding a Device67
- Exporting Patient Information to the Pachmate 268
- Initiating Measurement Transfer Using the Pc Software70
- Initiating Measurement Transfer Using the Pachmate 272
16 Changing Batteries75
- Changing the Batteries75
17 Care and Maintenance76
- Cleaning and Disinfecting the Probe Tip76
- Cleaning the Unit77
- Transport and Storage Conditions77
- Operating Conditions77
18 Troubleshooting Guide78
19 Service79
- Repairs and Customer Support79
- Viewing Model and Serial Number79
- Warranty80
20 Manufactured by Dgh Technology, Inc80
21 Authorized European Representative81
22 Regulatory Compliance81
- Emi/Emc Compliance81
- Wireless Radio Module Regulatory Compliance83