Operation 31
6.6 Terminating a Program
Programs such as the packaging program or the pump cleaning program can be terminated at any
time.
1. Terminate the program.
10-program control system Press the – / STOP button.
ACS Press the STOP button.
The program will be terminated and the vacuum chamber is decompressed.
6.7 Changing the Program Settings
6.7.1 10-Program Control System
10 programs are available. Programs 1 – 9 can be adjusted by the user. Program 0 is intended
for servicing purposes only. This section describes the units and limits of the parameters and how
parameters can be adjusted.
See Operating Elements of the 10-Program Control System on page 23 for an overview of the
operating elements of the 10-program control system.
1. Press the PROG 0 – 9 button to select the program you wish to change.
2. Press the REPROG button to select the programming mode.
The function display will start flashing.
3. Use the Cursor key to scroll to the desired parameter.
The LED in front of the selected function will light up.
4. Press the – / STOP button and the + / VACUUM STOP button to adjust the value.
5. Press the REPROG button to activate the new parameter.
The function display will stop flashing.
6.7.1.1 Vacuum
During the cycle, the air is removed from the chamber until the set time or pressure has been
reached, depending on the selected model (time-controlled or sensor-controlled).
1. Press the PROG 0 – 9 button to select the program for which you wish to set the Vacuum
option.
2. Press the REPROG button to select the programming mode.
The function display will start flashing.
3. Use the Cursor key to scroll to the parameter Vacuum.
The LED in front of the selected function will light up.
4. Press the + / VACUUM STOP button to adjust the value.
5. Press the REPROG button to activate the new parameter.
The function display will stop flashing.
To Next Page
Loading...
