Diamond Boxer - Seal; Soft-Air

Operation 42
To set the Tenderising option, follow the steps below:
1. Press the cursor keys
◄
and
►
and select the program Tenderising.
2. Press Enter to open the menu.
3. If Tenderising is not enabled, enable it. Press Enter and use the cursor keys
▲
and
▼
to turn
ON Tenderising. Press Enter.
4. Use the cursor keys
▲
and
▼
to go to the value for the Tenderising and press Enter.
5. Set the desired value using the cursor keys
▲
and
▼
and press Enter.
6. Use the cursor keys
▲
and
▼
to go to the value for the Tenderising Time and press Enter.
7. Set the desired value using the cursor keys
▲
and
▼
and press Enter.
8. Use the cursor keys
▲
and
▼
to go to the value for Accuracy and press Enter.
9. Set the desired value using the cursor keys
▲
and
▼
and press Enter.
10. Press the cursor key
◄
to return to the menu.
11. Close the lid to start vacuuming.
6.7.2.13 Seal
This is the time that the sealing wire and/or the cut-off wire are heated. The longer the time, the
more heat is transferred to the bag.
As an option, the machine can be equipped with a Seal 1-2 option. This means the seal wire is
activated separately from the cut-off wire. This way the cut-off wire can be activated a bit longer, to
cut through thicker bags.
To set the Seal option, follow the steps below:
1. Press the cursor keys
◄
and
►
and select the program Seal.
2. Press Enter to open the menu.
3. Use the cursor keys
▲
and
▼
to go to the value for the Sealing Time and press Enter.
4. Set the desired value using the cursor keys
▲
and
▼
and press Enter.
When Seal 1-2 is activated, the cut-off time cannot be set lower than the seal time.
5. Press the cursor key
◄
to return to the menu.
6. Close the lid to start sealing.
6.7.2.14 Soft-Air
This is the time that air is softly released into the chamber after sealing has taken place.
To set the Soft-air function, follow the steps below:
1. Press the cursor keys
▲
and
▼
and select the program Soft-air.
2. Press Enter to open the menu.
3. If Soft-air is not enabled, enable it. Press Enter and use the cursor keys
▲
and
▼
to turn Soft-
air ON. Press Enter.
4. Use the cursor keys
▲
and
▼
to go to the value for the Soft-air time and press Enter.
5. Set the desired value using the cursor keys
▲
and
▼
and press Enter.