Maintenance 49
Activity * 1-D 1-W 6-M 1-Y 4-Y
Replace the plastic lid. X
* 1-D = Daily, 1-W = Weekly, 6-M = Every 6 months, 1-Y = Annually, 4-Y = Every 4 years
7.2 Cleaning the Machine
Never clean the machine using a high pressure cleaner.
Do not use any aggressive or toxic cleaning agents.
Do not use any cleaning agents containing solvents.
1. Clean the surfaces with a soft, damp cloth. You can also apply a cleaning agent to the
machine and wash it with clean water.
7.3 Running the Pump Cleaning Program
The pump cleaning program runs the vacuum pump for 15 minutes. During the program, the pump
and the oil reach the operating temperature. Moisture in the pump is absorbed by the oil. The high
temperature causes any moisture in the pump to evaporate, and minimises the risk of corrosion.
It is advisable to run the program before using the machine for the first time, after the machine has
been stationary for a lengthy period of time, and especially prior to changing oil.
Run the pump cleaning program every week. If you package moisture-containing products, such as
soups and sauces, the pump cleaning program should be run every day.
1. Select the pump cleaning program.
10-program control system Press the Pump Cleaning Program button.
ACS Press the
▲
button or the
▼
button to browse to the pump
cleaning program.
2. Close the lid to start the pump cleaning program.
The pump cleaning program will run for 15 minutes.
7.4 Removing Oil, Refilling Oil
This section describes how to remove oil from the pump and how to refill the oil.
See Vacuum Pump on page 20 for an overview of the pump parts.
If the machine remains unused for a prolonged period of time, the oil must be removed from the
pump. This is necessary because moisture and dirt in the oil may affect the pump, causing the
pump to jam at the next use.
To Next Page
Loading...
