(In MDA mode, continuous changing of screen may appear. To avoid this, press left and up
arrow on the keypad in any order.)
MAIN:
Legacy Diskette A: 1.44/1.25 MB
Primary Master: FlashDisk SDTE-XX
ADVANCED:
– PNP OS Installed: No
– Reset Configuration Data: No
▶ I/O device configuration:
Local Bus IDE Adapter: Disabled
Floppy disk controller: Enabled ; [in case of Floppy drive]
Base I/O address: Primary
Serial Port A: Enabled
Base I/O address: 3F8
Interrupt: IRQ4
Serial Port B: Enabled
Base I/O address: 2F8
Interrupt: IRQ3
Parallel Port: Enabled
Mode: EPP
Base I/O address: 378
Interrupt: IRQ7
▶ Watchdog Settings
Mode: Disabled
I/O Chip Select:
I/O Base: Disabled
– Halt on Errors: No
SECURITY:
Fixed disk boot sector: Normal
Virus check reminder: Disabled
System backup reminder: Disabled
BOOT:
Quick Boot mode: Enabled
▶ Boot Device Priority:
– CD-ROM Drive
– Hard Drive
DV-XX (Slave device)
FlashDisk SDTE-XX
Bootable Add-in Cards
– Removable Devices
Legacy Floppy Drives
– Network Boot
To Next Page
Loading...
