Diatron Abacus + - Printing Errors

Diatron MI PLC
rev 1.09
66
7.1.4. Printing errors
Code
Message
Reason(s)
Remedy
1400
Printer error %d
Printer error!
Check the connections between the
instrument and the printer and
check the printer setup in the
Settings/Printer settings sub-menu.
1401
Printer is out of paper
and error %d
Printer is out of paper
and there are some
other printer errors!
Feed the printer with paper. Check
the connections between the
instrument and the printer and
check the printer setup in the
Settings/Printer settings sub-menu.
1402
Printer is out of paper
Printer is out of
paper!
Feed the printer with paper.
1403
Printer was not set up
correctly
The selected printer
type does not match
to the printer!
Modify the printer setup in the
Settings/Printer settings sub-menu.
1404
Paper width is too
large
Paper width steps
over the margin!
Modify the paper setup in the
Settings/Printer settings sub-menu.
1405
Paper height is too
large
Paper height steps
over the margin!
Modify the paper setup in the
Settings/Printer settings sub-menu.
1406
Paper width is too
small
Paper width steps
over the margin!
Modify the paper setup in the
Settings/Printer settings sub-menu.
1407
Paper height is too
small
Paper height steps
over the margin!
Modify the paper setup in the
Settings/Printer settings sub-menu.
1408
Left margin is too large
Left margin is too
large!
Modify the margin setup in the
Settings/Printer settings sub-menu.
1409
Top margin is too large
Top margin is too
large!
Modify the margin setup in the
Settings/Printer settings sub-menu.
1410
Spacing is too large
The distance
between two results
is too high!
Modify the vertical spacing setup in
the Settings/Printer settings
submenu.
1411
Error #%d in printer
initialization!
Printer software error!
Check the connections between the
instrument and the printer and
check the printer setup in the
Settings/Printer settings sub-menu.
Try to make a software upgrade.