OPERATOR’S MANUAL
GAC® 2100 Grain Analysis Computer (Blue, Gray, Agri Models)
11001-1688-201609
56 INSTRUMENT SETUP
3. Select the DATA BITS, PARITY and STOP BITS in that order. The
items for the COM1 and COM2 port cannot be changed:
– DATA BITS – Set for 8-bit character lengths.
– PARITY – Set to NONE by using the Left/Right Arrow keys.
– STOP BITS – Set to 1.
4. After editing is complete, select the Previous Page key to return to the
Communications menu for the next selection.
Figure 45
Accessing the COM1 Serial Data Setup Screen
To Configure COM1 or COM2 CONTROL LEAD SETUP:
(4 or 8 Keys from the Communications menu):
Both the COM1 and COM2 CONTROL LEAD SETUP selections are similar
and therefore described together in this procedure (Figure 46). Differences
are noted as applicable.
1. After completing steps 1 through 4 from the basic entry procedure, edit
the configuration of the COM1 Port screen. The COM1 (DCE) Control
Lead Setup menu displays two lines, refer to Accessing COM
Control Lead Setup screens.
The busy line, BUSY (11), notifies the GAC 2100 when the buffer in the
printer (computer) is full and cannot accept more data. The polarity of
this line is important and is set to be compatible with the printer. The
SELECT ITEM NUMBER
(NEXT PAGE: STATUS)
ENTER ACCESS CODE: __
COM1 SERIAL DATA SETUP
BAUD RATE : 1200
DATA BITS : 8
PARITY : NONE
STOP BITS : 1
SETUP MENU
1: CLEAR COUNTER
2: ID OPTIONS
3: OUTPUT OPTIONS
4: EDIT ACCESS CODE
5: DATE/TIME MENU
6: LABELS MENU
7: COM MENU
8: SERVICE MENU
COMMUNICATIONS MENU
COM1 SERIAL DATA SETUP
1: COM PORT SELECT
2: COM1 FORMAT
3: COM1 DATA SETUP
4: COM1 CONTROL
5: non-active
6: COM2 FORMAT
7: COM2 DATA SETUP
8: COM2 CONTROL
TO CHANGE
SELECT ITEM NUMBER
<more>
To Next Page
Loading...
