Digi XBee SX 868 - Network & Addressing Commands

AT commands Network commands
XBee® SX 868 RF Module User Guide
119
Parameter range
0 - 0xFFFF
Default
0
UA (MAC Unicast Transmission Count)
This command applies to the XBee SX 868 RF Module.
This count increments whenever a MAC unicast transmission occurs that requests an ACK. Once the
number reaches 0xFFFF, it does not count further events.
You can reset the counter to any 16-bit unsigned value by appending a hexadecimal parameter to the
command.
Parameter range
0 - 0xFFFF
Default
0
%H (MAC Unicast One Hop Time)
This command applies to the XBee SX 868 RF Module.
The MAC unicast one hop time timeout in milliseconds. If you change the MAC parameters it can
change this value.
Parameter range
[read-only]
Default
0xF3
%8 (MAC Broadcast One Hop Time)
This command applies to the XBee SX 868 RF Module.
The MAC broadcast one hop time timeout in milliseconds. If you change MAC parameters, it can
change this value.
Parameter range
[read-only]
Default
0x204
Network commands
The following commands are network commands.